Cirrus 3CFM Manual de instrucciones descargar pdf (Pagina 14)

interference

Troubleshooting

PROBLEM CAUSE REMEDY

Model will not move/ No batteries in transmitter/model Install batteries

Battery installation is incorrect

Install batteries correctly, noting

+ & - symbols

Weak batteries in transmitter Replace/recharge batteries

Weak batteries in model Replace/recharge batteries

Radio interference Relocate or change crystals

Connector disconnection Reinsert connector(s)

Tx/Rx* crystal disconnected Push in crystal(s)

Dirty battery contacts Wipe clean with dry cloth

ON/OFF switch in ‘OFF’ position Move ON/OFF switch to ‘ON’

position

ON/OFF switch is defective Replace ON/OFF switch

No control of model Weak batteries in transmitter Replace/recharge batteries

Weak batteries in model Replace/recharge batteries

Radio interference Relocate or change crystals

Limited radio range/ Weak batteries in transmitter Replace/recharge batteries

Weak batteries in model Replace/recharge batteries

Transmitter aerial loose Tighten transmitter aerial

Transmitter aerial cannot be extended Replace transmitter aerial

Receiver aerial damaged/cut Return receiver for repair

Motor (electric model) not suppressed Fit motor suppressors

* Tx = Transmitter / Rx = Receiver

Please retain this information for future reference.

does not recieve a

signal

14

Cirrus 3CFM Manual de instrucciones Pagina 14