Cirrus 3CFM Instrucciones de operaciones descargar pdf (Pagina 8)

Page 8

q Push the transmitter antenna down into the moulded hole in the top of the transmitter.

q Thread the antenna (clockwise) into place and tighten it gently until it stops.

IMPORTANT: Do not force the antenna into place or tighten it too strongly. Doing

so could cause damage to the antenna and/or transmitter.

q Check to make sure that the transmitter ON/OFF switch is in the 'OFF' position.

q Remove the plastic battery cover from the bottom of the transmitter.

Install 8 'AA' Alkaline batteries into the battery tray, double-checking to make sure

that the polarity (+/-) is correct.

Reinstall the battery cover and set the transmitter aside for now.

q Check to make sure that the receiver ON/OFF switch is in the 'OFF' position. 'ON'

and 'OFF' are moulded into the switch cover plate.

q Open the battery box cover by removing the retaining clip and pulling up on the front

of the battery box cover. The battery box cover is hinged at the back.

q Remove the battery holder from the battery box.

PRO TIP: After installing the batteries into the battery holder in the next procedure, we recommend tting a rubber band or a nylon

cable tie around the battery holder. This will prevent the batteries from coming loose when doing jumps, etc.

q Install 4 'AA' Alkaline batteries into the battery holder, double-checking to make sure

that the polarity (+/-) is correct.

q Reinstall the battery holder into the battery box and secure the battery box cover

back into place, using the retaining clip.

IMPORTANT: Make sure that the batteries are pushed rmly into place. They should not be loose. If for any reason the plug from

the battery holder (male plug) is not plugged into the switch (female plug), plug them together now, making sure that the polarity

is correct. For safety, the plugs can t together only one way.

Upgrading your transmitter and receiver to use rechargeable NiCD or NiMH batteries is

easy and recommended. You will need to purchase 8 'AA' rechargeable NiCD or NiMH

batteries for the transmitter, a 5 cell 1200mAH (or higher capacity) NiMH battery pack

for the receiver, and a compatible transmitter/receiver (Tx/Rx) charger.

For UK/Europe:

We recommend the Ripmax P-FBC10D/4 (UK) / P-FBC10D/4EUR (Europe), Tx/Rx

NiCad/NiMH AC Charger 70/70mA.

For North America:

We recommend the Airtronics 95033Z 110V AC 75mA Dual Charger.

UPGRADE TIP

Charger for UK/Europe

Charger for

North

America

5-Cell NiMH Receiver Pack

Transmitter

NiCDs/

NiMHs

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 63 64

Sin comentarios

Cirrus 3CFM Instrucciones de operaciones Pagina 8